The CZickness X

The #1 community for Gun Owners in Indiana

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!
  • Status
    Not open for further replies.

    RustyHornet

    Grandmaster
    Rating - 100%
    13   0   0
    Jun 29, 2012
    18,481
    113
    Fort Wayne, IN
    It's slick out there boys! Making good use of those YakTrax on the boots. Speed walking across the iced over lot while everyone else is barely crawling. Makes me feel like I'm special.
     

    88E30M50

    Grandmaster
    Site Supporter
    Rating - 100%
    12   0   0
    Dec 29, 2008
    22,920
    149
    Greenwood, IN
    I finally got around to swapping hammers between my P01 and 40P last night. If you remember, I got the Pro package for the P01 last summer, but had issues with the decocker. Namely, when I decocked the gun, the decocker would overtravel and stick until the hammer was pulled back. I swapped the factory hammer back into the gun and the issue disappeared. Since I have the full Pro package on my 40P, I thought I'd swap hammers to see if the issue stayed with teh gun or with the hammer. It stayed with the gun, so I have to assume that the hammer is fine. Next up, I'll swap the entire sear cage to see if that makes a difference. I'm thinking that it will. If the issue is in the sear cage, I need to figure out what is out of spec in there and then replace it with a new part.
     
    Status
    Not open for further replies.
    Top Bottom