louielouie
Plinker
I have a PSA upper and decided to change out the gas block as part of a make-over.
I got the flash hider off fairly easily, but then I ran into the 2 taper pins that hold the FSB in place.
I ruined about 4 punches and did not even "phase" the taper pins.
I called to verify that they should come out left to right and I was told that is correct.
I am ready to take it to a gunsmith, but the only gunsmith I know in Southern Indiana is Gary Growe (here in Columbus) and he is always busy.
Can anyone point me to a gunsmith who might do these while I wait.
I don't mind driving up to 50 miles one way, but I have a bad back and any further than that is murder.
Thanks,
louielouie
I got the flash hider off fairly easily, but then I ran into the 2 taper pins that hold the FSB in place.
I ruined about 4 punches and did not even "phase" the taper pins.
I called to verify that they should come out left to right and I was told that is correct.
I am ready to take it to a gunsmith, but the only gunsmith I know in Southern Indiana is Gary Growe (here in Columbus) and he is always busy.
Can anyone point me to a gunsmith who might do these while I wait.
I don't mind driving up to 50 miles one way, but I have a bad back and any further than that is murder.
Thanks,
louielouie