Combat Commander is the second best fit in my hand (first being Luger P08)
The weight is just right for solid, sweeping motions. Points naturally and feels as if you could use it to conduct. (great balance)
Despite being 27-40 Oz. I hardly notice the weight. add to that the fact that commander...
Using MAC filtering as the only means for security is a bad idea. Sure, WEP is weak, but MAC addresses are sent in cleartext so any nutjob with a laptop and wireshark could sit and wait for you to connect then simply clone your MAC address. BAM! They're in.
Suppressing SSID sounds good in...
Shooters
660 Lincoln Hwy West
New Haven, IN 46774
(260) 749-0900
Fairly wide selection broken into type and caliber.
(Several cases of handguns, mostly steel/alumalloy. walls lined with long guns)
K&T Guns K & T Guns and Supplies
442 Lincoln HWY West
New Haven, IN 46774
(260) 749-4867
Mainly...
I was going to pick up a Benchmade tomorrow (last knife died), but found a Kershaw Onion for 20USD today.
I don't care for the opening mechanism (have to hold the knife at an unnatural angle in order to deploy) and the locking mechanism requires you to flip the knife in hand should your other be...
Ruger LCR [38Spl +p][$500]
S&W 642 [38spl +p][$600]
S&W M&P 340 [357][$750]
LCR isn't bad, 642 is better.. I just like the M&P (357 helps :D)
Note: J-frames OK for light carry, but I usually go for the autos.
Not a matter of which is better, just preference.
--edit--
@cosermann:
Not like...
If not here I'd be in Colorado, Arizona third, Missouri fourth.
Stopped in a diner off of i70 last week called Bobbers (Missouri), one in three were either openly carrying or not bothering with concealment.
No one seemed to care/notice, food wasn't bad either.
Laws in Colorado aren't bad though...
People use ipods..?
My list isn't necessarily hard, just F'd up
Aiming for an inappropriate moment ;)
Buckethead - Vacuum Tube Implants
Electric Six - Showtime
Prodigy - Firestarter
The Dillinger Escape Plan - Come to Daddy
The Sensational Alex Harvey Band - Next
Nick Cave and The Bad...
My last system recently burned out in a thunderstorm. UPS, surge supressors... came in through the router (F'ing FIOS)
... So I dumped a couple grand into a new PC:
CoolerMaster HAF case (highly recommended)
ASUS P6T7 Motherboard
Intel i7 950 (was cheaper than the 920)
12GB OCZ Platinum DDR3...
Layer cheese cloth in a muffin tin.
Melt the slivers <over low heat on the stove or in the microwave>.
Use a basting brush with the liquid soap to coat the cheesecloth melding it to the tin.
Pour the rest of the soap, let it fully harden.
Remove from muffin tin by pulling on the cheese cloth...
It is possible <usually taken the other direction with a full slide on an officers frame>
I wouldn't try just dropping it in. Even if measurements look clear, too easy to mess things up.
If you Really want to do it, take it to a competent gunsmith.
(or jam it in and hope like mad it works :D)