Springfield XDm build question

[DJ48106]

I recently purchased a new springfield XDm 40 and I have been looking for a new barrel for it and ran across an EFK Fire Dragon ported .357 & a ported .40 barrel and had a question that if I use the .357 do I need to get a different clip to utilize the new barrel or will the existing one work with slight modification?

 

[IndyGunworks]

I recently purchased a new springfield XDm 40 and I have been looking for a new barrel for it and ran across an EFK Fire Dragon ported .357 & a ported .40 barrel and had a question that if I use the .357 do I need to get a different clip to utilize the new barrel or will the existing one work with slight modification?

one..... your 40 cal mag will work with .357 sig barrel....

two.... since when does swapping out barrels constitute a BUILD???

three..... its a MAGAZINE not a clip.

 

[DJ48106]

ok thank you and its just starting with the barrel then I'm going from there. I plan on a PRP trigger kit and Arredondo Extended Base Pad Kit as well

 

[Naptown]

one..... your 40 cal mag will work with .357 sig barrel....

two.... since when does swapping out barrels constitute a BUILD???

three..... its a MAGAZINE not a clip.

yeah, what he said. Oh yeah, and welcome to INGO.

 

[kingnereli]

ok thank you and its just starting with the barrel then I'm going from there. I plan on a PRP trigger kit and Arredondo Extended Base Pad Kit as well

I have a suggestion on the trigger kit and you can obviously take it or leave it. The PRP kit is just fine and will do the job. However, I would recommend the Springer Precision kit. It takes a little more fitting, but you get the added benefit of a stronger, solid stainless trigger bar and a lot better pre-travel results. YMMV.

 

[DJ48106]

awesome thanks. im open for any advice. i will check it out

 

[thescrambler]

Just shoot 40's they are a great round