Got one of the new INGO lowers, tried to install my CMC Trigger, and it seems that the holes do not align. The pins fit the lower alone fine, the trigger alone fine, but 'drop in instillation' it is not. The holes are off just enough for the pins not to go all the way through. The holes are set too far forward so cannot fit.
Tried searching, found a post on another site where the resolution was buying a different trigger group.
Any solution?
I prefer a drop in as opposed to separate components.
***** UPDATE *****
When trying to get the trigger pin out, I used to much hammer, and now the lower is broken-- completely my fault, so no complaint there. Will look at getting some other lower, and before purchasing, make sure that the trigger fits.
Will get some other custom engraving, and then will pass it on down the family line.
I really wanted an INGO one.
Thanks everyone for your assistance.
Tried searching, found a post on another site where the resolution was buying a different trigger group.
Any solution?
I prefer a drop in as opposed to separate components.
***** UPDATE *****
When trying to get the trigger pin out, I used to much hammer, and now the lower is broken-- completely my fault, so no complaint there. Will look at getting some other lower, and before purchasing, make sure that the trigger fits.
Will get some other custom engraving, and then will pass it on down the family line.
I really wanted an INGO one.
Thanks everyone for your assistance.
Last edited: