happyfiero
Plinker
hi
i finished my SKS underfolder , thought I would share.
I think it came out looking as stock as i could get.
Have fired about 200 rounds down it ,shoots as well as ever
.
Hand grip sits on a mount built in to the stock, and thread into the rear of the Trigger group
Some fitting was done to the trigger guard , shaved the sides
Grip sit proper and the , safety sits fully back.
Drilled and tapped a hole. To the back tab of the trigger group for the ak grip bolt
To clean you have to remove the single bolt in the grip then you can remove. and clean as you would any sks .
The underfolder stock is solid when extended both side lock function works as intended
the Chinese stock needed a little off the sides to match the contour.
sanded the whole with 180 stock, grip and upper guard and rear cover
4 coats of my red stuff stain . final sand
3 coats of clear to seal the deal
one ak sling
i finished my SKS underfolder , thought I would share.
I think it came out looking as stock as i could get.
Have fired about 200 rounds down it ,shoots as well as ever
.
Hand grip sits on a mount built in to the stock, and thread into the rear of the Trigger group
Some fitting was done to the trigger guard , shaved the sides
Grip sit proper and the , safety sits fully back.
Drilled and tapped a hole. To the back tab of the trigger group for the ak grip bolt
To clean you have to remove the single bolt in the grip then you can remove. and clean as you would any sks .
The underfolder stock is solid when extended both side lock function works as intended
the Chinese stock needed a little off the sides to match the contour.
sanded the whole with 180 stock, grip and upper guard and rear cover
4 coats of my red stuff stain . final sand
3 coats of clear to seal the deal
one ak sling