i have been a fan of TiteGroup. Mostly for the fact that in a few load books it was listed as the "accuracy load". It also has larger grains, so it goes a bit further than other powder and thus is cheaper.
since i'm not getting any answers in my other thread, i'll post it here also....
Ok guys i've decided to start with the most basic version, so is this EVERYTHING i'll need to start making ammo correct? (i have brass) I think i've got the right powder, primers, bullets, and dies. Is this everything i'll need? Do i have anything in there thats expensive and something else could be used?
Cabela's: Shopping Cart
Your link takes me to an empty cart. (probably my cart!)
Post the list of items and I'm sure you'll get some responses
I like LEE dies myself. The decapping pin will push up thru the top if you get a berdan primer case. You might want to get the deluxe carbide set with the "factory crimp die". +Lee gives you a shellholder.
Order some extra Lee Breech Lock Quick Change Bushings since the press comes with one, you'll want one for each of your dies. Once the dies are set you can quick change them for the different stages.
Before you buy your powder and primers, try check powdervalley.com I haven't ordered from them for two years, but they used to combine powder and primers for one hazmat fee.
Don't be afraid of the cheap "wolf" primers, I've used several thousand w/o any trouble.