How do you make the engravings white (or any other color) on a firearm. Not real sure I want to attempt the whole Testor Paint thing, and I saw something Googled that said to use wax crayons.
The Testor's paint thing isn't hard, and it's easy to clean up with a little thinner if you don't like it. I'd recommend it over crayons which melt and run when the slide gets hot, and is therefore a lot harder to clean up.
Check out this thread that describes how I did it:
It really wasn't hard at all, just a little time-consuming because of the fine detail. Also, the paint has so far held up to gun solvents for over a year so I don't have to keep re-doing it.
Stick with Scutter01 tips and you will be fine. It really is not as hard as you think. I felt the same way before I did one of mine and I put it off for a long time because I was too scared. Good luck!
I've only used crayons, and been pleased. The testors paint or laquer sticks from brownells are always brought up every time I've seen or heard discussion of the subject though so there must be something to it.